The minerals in the water in hard water areas can be a cause of yellow staining. As the toilet flushes, the water can splash upwards onto the underside of the seat, and as the water evaporates, itMix approximately one-quarter cup of baking soda with warm water. Stir it together to make a paste. Then, apply that paste to the stained toilet seat. Let the cleaner sit for 15-20 minutes. Then, scrub the toilet with a good amount of elbow grease, removing all the stains. For a quicker clean, make a paste of baking soda and water, slather it on the grates, and leave on for 10 to 15 minutes. Then crumple up a piece of aluminum foil and use it as a "sponge" to scrub the baking soda on the grates. Thoroughly rinse and dry. 15 of 15.
6 days ago · Scrub the bowl: Take a toilet brush and scrub the inside of the bowl, ensuring that you reach all areas. Pay special attention to the waterline, under the rim, and any stains. Let it sit: Allow the baking soda and vinegar mixture to sit in the toilet bowl for at least 15-30 minutes.
1– 2 cups vinegar. 1– 1 cup baking soda. There are actually two ways to use baking soda and vinegar in cleaning a toilet bowl. One way is to sprinkle a 1 ½ cup of baking soda into the toilet bowl, then shower or dribble the bowl with vinegar. Leave it for 10 to 30 minutes – check your emails, read your favorite blog or have a cup of The outcome is not a dangerous one. When you mix bleach with baking soda, what you get is an increased ability of the two. In the process of mixing the two items, you need to consider some factors. One of the things you have to decide is the nature of the bleach. Bleach, which contains chlorine, can be corrosive.We poured 1/2 cup of baking soda followed by 1 cup vinegar, following ARS’s formula, left it for 10 minutes, then poured half a gallon of hot water into the drain. The blockage cleared immediately. The clog, however, was minor — the drain still allowed water through, albeit very slowly.GDw4.